It may sound obvious to you but with the right equipment, experience, and assistance, you can easily install a chain link fence. But, make sure you take help from some top chain link fence companies in Palm City so that nothing gets dumped or destroyed so far. This link fencing will provide security to your property and is safe for both pets and children. But, when you are installing a fence by yourself, then you should be extra careful.
Also, if you are doing the privacy fence installation in Jensen Beach, then also you have to follow certain steps if you are installing the same in your home. Check with an expert so that you can look after the home very well. Now, in this blog, we have listed down some common steps to be followed for the installation of a chain link fence for better safety of your property.
Looking after Local Building Codes and Property Lines
The building codes may vary from building to building. So, you have to keep a close look on what the requirements are before you start up your project. You have to make sure that you are fully aware of where your property lines start and end so you don’t accidentally dig in your neighbour’s yard.
Designing and laying out your fence
This process is fulfilled by the top chain link fence companies in Palm City. The experts will ask you about the designing process and accordingly will assist in selecting the right fence. On the other hand, if you are opting for a DIY, then you have to first mark your fence line and the locations of the posts. As a result, you will have an idea of how much fence you should purchase for your property. It is suggested to better use spray paint to visualize your fence in a better way.
Digging up and establishing posts
Once you have dug up the hole, it is better to secure them with the help of concrete. According to our experts, it is recommended three times wider than the diameter of the post itself. Then, you need to place one-third of the post underground. For giving an aesthetic and beautiful appearance, you have to place the posts evenly about 4-10 feet apart.
Establishing the rails, post caps, tension bands
After setting up the posts, it's time to add tension bands that hold the fence to the end, corner, and gate posts. With the mallet, you have to place a cap on the gates, corner, and end posts. Also, you have to follow the instructions of the experts of the chain link fence companies in Palm City to ensure that they are oriented correctly. After this, establish the top rails through the caps.
Rolling out and attaching the fence material
Then, lay down the fence rolls. It will appear heavier than you think. Now, you have to unroll them along the length of the fence. Make sure while you weave it through the end of the fencing, you slide the vertical tension bar through the tension bands. This will help in protecting the fence to the end post and let you stretch the fence into place.
Tightening the fence material
You have to stretch the chain link fence some extra, otherwise, it will sag down. Pull the fence tight so as to eliminate any extra slack. Then, attach it with the help of the tension bar to the end post. However, it requires more strength, so you will require the help of one or two people.
Cutting out extra fence
You can easily remove the leftover past the tension bar by unlooping the top and bottom weave and finally pulling out the strand. After this, you have to tighten the bolts on the tensions bands and release the come-along.
Tie fencing to rails
Finally, separate wires known as tie wires and attach the fencing to the top of the rail of the fence. Then, slide the wire through a loop at the top of the fence link, around the rail, and back around to the fence, tightly putting it in place. At last, you can place tie wires every 24 inches along the top rail.
So, this is how you can place a chain link fence by yourself. Also, if you wish for privacy fence installation in Jensen Beach, then look for tips from the experts so that you can install them easily.